RV and Toy Hauler Blog » Mounts http://www.toyboxcovers.com/blog RV's, Toyhaulers, ATVs, Rhinos and Off Roading Wed, 28 Sep 2011 04:18:51 +0000 en hourly 1 http://wordpress.org/?v=3.1.2 Flagpole Holders http://www.toyboxcovers.com/blog/flagpole-holders-126.html http://www.toyboxcovers.com/blog/flagpole-holders-126.html#comments Fri, 24 Apr 2009 20:17:36 +0000 admin http://www.toyboxcovers.com/blog/?p=126

Read the rest of this entry

]]> If you need a special mount for your flagpole that will attach to your recreational vehicle you need look no further. Our reasonably priced flagpole holders are easy to install and are made in the USA.
Our awning mount is riveted to the top of your manual awning and will not interfere with the awning mechanisms. This flagpole holder is made for a solid sixteen-inch fiberglass flagpole. The only downside to this mount is wind resistance; you need to keep an eye on your flag on windy days.
Our versatile ground flagpole holders accommodate sixteen and twenty two feet fiberglass poles. No installation is needed for these holders, merely push them into the ground, if you are unable to push the end into the ground using a hammer will make the job easier.
Also available are flagpole holders that are mounted to the top railing of the rear ladder. These mounts are designed for the sixteen inch and twenty-two inch fiberglass flagpoles. For rigs designed with a back ramp, a special flagpole holder has been designed to hold a heavy-duty sixteen or twenty two-inch fiberglass flagpole. This holder once permanently attached will not interfere with opening or closing the door. We have another mount that can be placed anywhere on your ladder which eliminates the need to climb up and down the ladder to put up or take down your flag.
If you are looking for a flagpole holder that you can permanently attached to a shed or wood fence we have a wall mount designed to do just that. These mounts are easy to install and can accommodate your sixteen or twenty two inch fiberglass flagpole.
Our solid bumper mount will fit any four-inch rear bumper. This mount can also be attached to a four-inch channel frame located on the front of a pull trailer. This mount will support a sixteen-inch fiberglass flagpole.
We also stock flagpole holders that will mount on the frame of your recreational vehicle if it has a six-inch frame. This mount is designed to accommodate a twenty-two inch heavy-duty fiberglass flagpole.
We also have an unparalleled flagpole holder that mounts into the trailer hitch. This holder can be used on virtually any vehicle with the ability to tow a trailer.
We also have a very unusual tire mount. This flagpole holder is equipped with a flat piece you set down in front of your rear tire, and then you drive onto the plastic piece holding it firmly in place. This flagpole holder holds a twenty two inch fiber glass flagpole. This same mount can be placed beneath the rear stabilizers or the front jacks of a fifth wheel trailer.
We also have mounts in stock designed to hold your television or internet satellite dishes that make it much easier to locate the needed signals for these services.

So if you are looking for the very best in flagpole holders look no farther then www.toyboxcovers.com

]]> http://www.toyboxcovers.com/blog/flagpole-holders-126.html/feed 0